Table of Contents
Advertisement
Available languages
Available languages
5
Select the desired timing to capture the image by pressing the ı or ∫ button.
Timing
To capture the image just after the CAPTURE command is received
To capture the image with the timing pulse input to REMOTE 2 connector
a) When IMMED. CAP is set to ON, display the source image on the video monitor when sending
the timing pulse to the printer. The printer operation is only to capture the image when receiving
the pulse.
b) For detailed information on the timing pulse to REMOTE 2 connector, see page 101.
Select ON when you want to capture the image at the precise timing by
controlling from the computer.
Note
To control the printer remotely using the remote control unit, set the
IMMED.CAP item on the FUNCTION SETUP menu to OFF.
FU NC T I ON S E T UP CO L OR n n n
P R E S S
P R N SE TU P
A U TO L I V E
OF F / ON
I MM ED. CA P. OF F / ON
RM2 F U NC
/ S RC & C AP
CL E AR
/ OF F
Q 1 A 1
2 H F
Switch the desired timing selection to green
by pressing the ◊ or √ button.
6
Select RM2 FUNC by pressing the ◊ or √ button.
FU NC T I ON S E T UP CO L OR n n n
P R N SE T UP
PRE SS
A U T O L I V E
OF F / ON
I MME D . C A P.
OF F / ON
R M 2 F U NC
P R I N T /
C L E A R
A L L /
Q 1 A 1
2 H F
Position the cursor to RM2 FUNC
by pressing the ◊ or √ button.
I MMED. CA P.
Display the desired timing selection in
S
capital letters by pressing the ◊ or √ button.
RM2 F U NC
P R I N T /
Display RM2 FUNC by pressing the ◊ or √
S
button.
Selection
a)
ON
b)
OFF
:
OF F / o n
:
Continue to next page m
Installation and Adjustment
87
Advertisement
Chapters
Table of Contents
