Panasonic KX-TG6611E Operating Instructions Manual page 42

TG6611-6621E(e).book Page 42 Tuesday, December 7, 2010 2:00 PM
Useful Information
Problem Cause/solution
The unit does not work. L Make sure the batteries are installed correctly (page 12).
L Fully charge the batteries (page 12).
L Check the connections (page 11).
L Unplug the base unit's AC adaptor to reset the unit and turn off
L The handset has not been registered to the base unit. Register
The handset display is L The handset is not turned on. Turn the power on (page 16).
blank.
I cannot hear a dial tone. L Make sure that you are using the supplied telephone line cord.
L The base unit's AC adaptor or telephone line cord is not
L Disconnect the base unit from the telephone line and connect
Programmable settings
Problem Cause/solution
The display is in a L Change the display language (page 16).
language I cannot read.
While programming, the L A call matching an entry in the call barred list is being received.
display returns to standby
mode.
I cannot activate the eco L You cannot set eco mode when you set the repeater mode
mode.
I cannot register a L The maximum number of handsets (6) is already registered to
handset to a base unit.
L You entered the wrong PIN. If you forget your PIN, see "I
I cannot remember the L Change the PIN using the following method.
PIN.
42
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
the handset. Reconnect the adaptor, turn on the handset and
try again.
the handset (page 29).
Your old telephone line cord may have a different wiring
configuration.
connected. Check the connections.
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
Wait and try again later.
"On". If required, set the repeater mode to "Off" (page 29).
the base unit. Cancel unused handset registrations from the
base unit (page 29).
cannot remember the PIN." (page 42).
1
8(132
2
*7)))
3
Enter the new 4-digit base unit PIN. s M s {ic}