Panasonic KX-TG6611E Operating Instructions Manual page 29

TG6611-6621E(e).book Page 29 Tuesday, December 7, 2010 2:00 PM
Important:
L The additional handset model
recommended for use with this unit is noted
on page 5. If another handset model is
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is
not registered to the base unit (for example, _
is displayed even when the handset is near the
base unit), re-register the handset.
1
Handset:
8(13)
2
Base unit:
Proceed with the operation for your
model.
■ KX-TG6611/KX-TG6612/KX-TG6613
Press and hold {x} for about 5
seconds. (No registration tone)
■ KX-TG6621/KX-TG6622/KX-TG6623/
KX-TG6624
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start ringing,
press {x} again to stop, then repeat
this step.
L The next step must be completed
within 90 seconds.
3
Handset:
M s Wait until "Base PIN" is
displayed. s Enter the base unit PIN
(default: "0000"). s M
L If you forget your PIN, see page 42.
L When the handset has been registered
successfully, w is displayed.
Note:
L While registering, "Base in
registering" is displayed on all
registered handsets.
L When you purchase an additional handset,
refer to the additional handset's installation
manual for registration.
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programming
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
8(131
L All handsets registered to the base
unit are displayed.
2
{r}: Select the handset you want to
cancel. s M
3
{r}: "Yes" s M
L A confirmation tone sounds.
L The handset does not beep when
cancelling its own registration.
4
{ic}
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
L Before registering the repeater to this base
unit, you must turn the repeater mode on.
L Do not use more than one repeater at a
time.
Setting the repeater mode
1
8(138
2
{r}: Select the desired setting. s M
s {ic}
Note:
L After turning the repeater mode on or off, _
is displayed on the handset momentarily.
This is normal and the handset can be used
once w is displayed.
29