Connecting And Operating; Bridge Connection - Pioneer M-AX10 Operating Instruction

CONNECTING AND OPERATING

BRIDGE CONNECTION

You may use audio cords to connect the analogue outputs of up to two control amplifiers to INPUT 1
terminal or INPUT 2 terminal of this appliance as required. It is also possible to utilise the appliance's
attenuator function to connect a CD player or other source components directly without passing
through the control amplifier.
CD player
Control amplifier
Speaker system
(right-hand side)
Take care to connect only to a speaker
system with an impedance of at least 6
½. To ascertain speaker impedance you
should refer to the manual which came
with the system.
10
BEWARE
AC IN
Finally, connect to the wall plug.
If the impedance of your speakers is less
than 6 ½, you cannot use a bridge
connection. You should employ a dual
connection instead.
Speaker system
(left-hand side)