Front Surface - Pioneer M-AX10 Operating Instruction

FRONT SURFACE

POWER
Press to switch the appliance on and off.
OPERATION MODE
Use this to switch between the three modes:
bridge, dual and separate. Be sure to turn the
power off before switching between modes.
Switching with the power on will activate the
warning circuit. The mode illumination light
and mode indicator will flash, and the output
will be muted.
If this happens, you should turn the
operation mode switch back to its original
position. The flashing will stop, and your
M-AX10 will return to normal.
ATT HOLD
This button
OPERATION MODE switch is pointing to
SEPARATE.
Pressing the ATT HOLD (attenuator hold)
button while in separate mode allows
whatever attenuation has been set with the
ATTENUATOR knob to be retained.
Pressing it again will cancel the operation.
Note, however, that it is not possible to turn
ATT HOLD on and off while the output is
muted (eight seconds after switching the
power on).
8
0 -
1
4
is activated only
8 ~ 9
=
3 2 5 6
ATT THROUGH
BEWARE: If this button is used the volume
will be heard at maximum level.
Pressing the ATT THROUGH button for two
seconds or longer causes the sound to be
output through the speakers without passing
through the attenuator circuit. However,
because the mute circuit is activated, there is
no sound for five seconds after the button is
depressed. The sound will emerge from the
speakers
THROUGH button is pressed. Note that it will
be at maximum volume. Pressing the button
again will cancel the operation.
ILLUMINATION
Pressing the ILLUMINATION button once,
if the
twice or three times alters the brightness of
the panel light, mode illumination light and
mode indicator as indicated below.
Pressing it a fourth time will return the lights
to their initial settings.
Initial
setting
Press
once
Press
twice
Press
three
times
7
five seconds after
Panel Mode
light illumination indicator
light
Bright On
Dim On
Off On
Off Off
the ATT
Mode
On
On
On
Off