How To Operate In Dual Connection Mode - Pioneer M-AX10 Operating Instruction

HOW TO OPERATE IN DUAL CONNECTION MODE

2 4 1
You should begin with the power switched off.
1. TURN THE OPERATION MODE SWITCH TO 'DUAL'
Make sure the power is switched off.
If the power is on, the warning circuit will be
activated, the mode illumination light and mode
indicator will flash, and there will be no sound.
TURN THE POWER ON
2.
Check to see that the word DUAL on the mode
indicator has lit up.
Note that it will not light up if the illumination button
is switched off.
3. USE THE INPUT BUTTON TO SELECT THE INPUT DEVICE
The selected input indicator will light up.
4. PRESS THE ATT THROUGH BUTTON FOR TWO
SECONDS OR LONGER
The ATT THROUGH indicator will light up, and the
sound will emerge after a delay of five seconds. It will
be at maximum volume, so you should adjust the
volume on the control amplifier in advance.
IF NO CONTROL AMPLIFIER IS CONNECTED ...
Do not press the ATT THROUGH button, and use the
ATTENUATOR dial to adjust the volume.
CONNECTING AND OPERATING
3
13