Philips FTR9964 User Manual page 11

General
Setup
Programme title
General
Setup
Teletext level 2.5
General
Setup
Set/Change code
General
Setup
Centre mode
Installation
10 10
&
é
Yes / No
&
é
"
On / Off
&
é
"
&
é
"
'
(
Yes / No
Programme title
Select with the cursor down.
Programme title
Press the cursor right to select
When selected , after the selection of a TV programme or after pressing
Yes
the i key on the remote control, a TV channel which broadcasts teletext
may transmit the name of the TV channel or the programme title.
When selected , the programme title will only appear after pressing the
No
i key, and not after the selection of a TV channel.
Teletext level 2.5
Some broadcasters offer the opportunity to see more colours, other
background colours and nicer pictures in the teletext pages.
Select with the cursor down.
Teletext level 2.5
Press the cursor right to select
this feature.
Press the cursor right again to select
more neutral teletext layout.
The selection made is valid for all channels which broadcast teletext.
Note: It may take a few seconds before teletext broadcast switches over to
Teletext level 2.5.
Set/Change code
The Child lock feature (see TV, Features, p. 18) allows you to lock channels to
prevent children from watching certain programmes.
To watch locked channels, you need to enter an access code.
The Set/Change code menu item allows you to create or change a Personal
Identification Number (PIN).
Select / with the cursor down.
Set Change code
If no code exists yet, the menu item is set to
instructions on screen.
If a code has previously been entered, the menu item is set to
Follow the instructions on screen.
All number combinations from 0000 to 9999 are valid numbers.
The General menu reappears with a message confirming that the code has
been created.
Important:You have forgotten your code !
Select in the General menu.
Set/Change code
Press OK.
Press the cursor right.
Enter the overriding code 8-8-8-8.
Press the cursor again and enter a new personal 4-digit code.
The previous code is erased and the new code is stored.
Centre mode (not available in combination with a speakerless monitor)
When you have connected a multi channel audio receiver to the receiver box
(see Connect peripheral equipment, p. 30) and you have selected
, the loudspeakers of the monitor will act as centre speaker, making
mode Yes
a separate centre speaker unnecessary.
or
Programme title Yes No
to take advantage of
Teletext level 2.5 On
Teletext level 2.5 Off
. Follow the
Set code
.
if you like the
.
Change code
Centre