Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Philips FTR9955
Summary of Contents for Philips FTR9955
- Page 1 Flat TV Flat TV...
- Page 2 MAINS INLET VGA 1 VGA 2 RS232 ~ MAINS VGA 1 VGA 2 RS232 DVI-D VGA 2 VGA 1 ~ MAINS AUDIO CABLE ANTENNA • VIDEO AUDIO OUT CVBS 1 CVBS 2 Cb/Pb Cr/Pr R/Cr/Pr B/Cb/Pb EXTERNAL CONTROL CVBS B/Pb/Cb VIDEO 1 (AV1) RC-OUT...
- Page 3 Return your Warranty Registration card today to ensure you receive all the benefits you’re entitled to. Once your PHILIPS purchase is registered, you’re eligible to receive all the privileges of owning a PHILIPS product. So complete and return the Warranty Registration Card enclosed with your purchase at once, and take advantage of these important benefits.
- Page 4 IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions.
-
Page 5: Table Of Contents
If this instruction manual does not give an answer or if ‘Before Calling Service’ do not solve your TV problem, you can call your Local Philips Customer or Service Center. See the supplied World-wide guarantee booklet. Please, have the Model and Product number... -
Page 6: Preparation
A green indicator and the screen light up. Note: After turning on your TV receiver box with the power switch, at the MAINS The green indicator blinks every time you press a button on the remote control. -
Page 7: Use Of The Remote Control
Press the OK button to display a new series of frozen pictures. Note: Continuing to hold the S button down will cycle the TV through the various modes (Freeze, Replay, Photo Finish). OK Press this button to activate your choice or to confirm when in the menus. -
Page 8: Buttons In Front Of The Tv Receiver Box
MENU Use the - and + buttons to select the menu item. VOLUME Use the - and + buttons to select the TV, Settings, Install menu or Exit, CH/PR Channels or to select the submenu items. Note: - Sometimes not all the menu items are visible on the screen;... -
Page 9: Use Of The Remote Control
In the menu system, you can set surf to two- or nine-channel.(See Settings, General Surf, p. 10.) Press this button to select the previously viewed TV channel or source in case of a Two channel surf, or to select the surf ring in case of a Nine channel surf. -
Page 10: To Use The Menus And The Menu System
When items (balls) of a menu level are more numerous than can fit comfortably on the TV display, only a portion of the items are shown as balls along the pipe.Those omitted are indicated by a cluster of balls which indicates that there are ‘more’. -
Page 11: Store Tv Channels
‘ Press the cursor down to select Note: All channels must be unlocked in order to autoprogram. If requested, enter your PIN code to unlock all channels. (See Channels in the TV menu, p. 14.) Press the cursor right. §... -
Page 12: Select Tv Settings
Select TV settings The Settings menu allows you to adjust initial settings, i.e. those which are not related to the installation of the TV channels. It contains items that control the settings of the receiver’s functions, features, services and accessory devices you may have connected. - Page 13 Not all TV programs and product commercials are made for broadcast with Closed Caption information included. Refer to your area’s TV program listings for the TV channels and times of Closed Caption shows. The captioned programs are usually noted in the TV listings with service marks such as ‘CC’.
-
Page 14: Tv Menu
MENU menu. Note: When the main menu is accessed from the keypad in front of the TV receiver box, it has an additional Exit item, which lets you dismiss the menu. Warning: The main menu is completely different when a VGA source is displayed. -
Page 15: Sound Menu
Headphone volume This control allows you to adjust the volume level of the headphone. Sound mode Surround Mode can only be selected when the sound of the TV channels is stereo. When is selected, it seems as though the Sound mode On loudspeakers are spread further apart from one another. -
Page 16: Features Menu
0, the sleeptimer is turned off. One minute before the sleeptimer expires, a message appears that the TV will turn off in 60 seconds or you may cancel the sleeptimer by pressing the OK button.You can always turn off your TV earlier or change the set time. -
Page 17: Tv Ratings Lock
(S) Sex (V) Violence TV Ratings Lock Your TV is equipped with a V-chip.This allows you to control access to individual programs based on their movie and TV ratings. The program content advisory data are sent by the broadcaster or program provider. -
Page 18: Movie Ratings Lock
Channels Movie Ratings Lock PG-13 NC-17 Use of the menus Movie Ratings Lock This function allows you to control access to individual movies based on their MPAA ratings (Motion Picture Association of America). & Select with the cursor down. Movie Ratings Lock A list appears, showing all valid MPAA content ratings. -
Page 19: Dual Screen/Pip (Ftr 9964 Only)
The TV tunes to the picture which was highlighted in Dual Screen mode. Notes: - TV or Movie ratings: When Dual Screen mode is activated, a message with a PIN entry is summoned as TV and Movie ratings locks do not apply in Dual Screen. -
Page 20: Multi-Pip (Ftr 9964 Only)
Notes: - TV or Movie ratings: when Multipip is activated, a message with a PIN entry is summoned as TV and Movie Ratings locks do not apply in Multipip. Select with the cursor button up/down to indicate whether you want to suspend V-chip blocking as long as Multipip is activated, or until the TV is turned off. -
Page 21: Connect Accessory Devices
AV 2 VIDEO VIDEO S VIDEO L AUDIO R AUDIO VIDEO & Connect the cable TV antenna 1 to the cable box’s S VIDEO L AUDIO R AUDIO CABLE é Connect the cable box’s “ Proceed with the as above described procedure for... -
Page 22: Satellite Receiver
S-VIDEO receiver to the jack of VIDEO AV1 IN Connect the cable TV CABLE 1 to the your VCR. Connect another RF cable 2 from the output of your VCR to the receiver’s ANTENNA/CABLE Connect the satellite antenna cable 3 to the satellite receiver’s... -
Page 23: Multi Channel Surround Receiver
Surround Sound.The volume has to be controlled via the multi channel Surround receiver. Note: No sound will be heard when a TV channel or external source is blocked via the Channel Lock menu (see p. 14). Connect Accessory Devices input. -
Page 24: Connecting Accessory Devices
Lock menu (see p. 14), also the headphone is muted. When Dual Screen/PIP is activated (see p. 17) (FTR 9964 only): - if the main screen displays a TV channel picture, you hear the sound from the Dual Screen/PIP picture through your headphone;... -
Page 25: Setting The Remote Control To Work Accessory Devices
Setting the remote control to work accessory devices Your remote control is set to work your TV and many infrared remote (IR) control VCRs, Cable TV Converter Boxes, DVD players, Satellite Receivers, etc. Press the accessory device you want to operate with this remote control. -
Page 26: Selecting Accessory Devices
This is however never the case with a computer connected to the VGA input. If you want to change to TV channels? Enter the channel number of the TV channel which you want to watch with the digit buttons. Only available when a VGA source has been connected and activated. See also the separate supplied instruction manual with your monitor. -
Page 27: Vcr Control Buttons
Do not switch channels or turn off your TV when you are recording through VIDEO OUT Note: When a TV channel or AV source is blocked because of a rating set via the Channels menu (see p. 14), also the record output picture and sound are muted. -
Page 28: Remote Control Direct Entry Codes For Accessory Devices
Panasonic ......0335 Philips ..... . .0296, 0919 Pioneer . -
Page 29: Remote Control Direct Entry Codes For Accessory Devices
Panasonic ....0517, 0659 Philips ..... . .0530, 0566 Pioneer . -
Page 30: Before Calling Service
• You can still use the buttons at the front of your receiver. • Press the TV button to be sure your remote control is in the TV mode (green indicator). No stable or not • Check if you have selected the correct VGA mode in your PC synchronized VGA picture •... -
Page 31: Tips
Modifications - The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Philips Consumer Electronics may void the user’s authority to operate the equipment. Cables - Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations. -
Page 32: Glossary
Multichannel Television sound (MTS) The broadcast standard that allows for stereo sound to be transmitted with the TV picture. Natural Motion Philips Technology that makes movement on television less jerky and appear more natural. NTSC (analog video signals) National Television Standards Committee format devised for TV broadcasting signals in the 1940s (525 lines: 60 Hz.) -
Page 33: Service/Warranty Information
Philips is not liable under any circumstances for any direct, indirect, special, incidental or consequential damages, howsoever incurred, even if notified of the possibility of such damages.) - Page 34 Toll-free numbers provided on the next page Note: If you reside in one of our Philips Factory Service Branch areas (see directory on back), you can contact the nearest Service Branch to obtain efficient and expedient repair for your product. If your product is In-Warranty, you should have proof-of-purchase to ensure No Charge Service.
- Page 35 50 à 75 miles (80 km à 120 km) du centre de service local. Cómo obtener un servicio oportuno y eficiente por correo, en casa o en persona para su producto a través de un centro Philips de servicio.