Quick Start; Taking Pictures; Taking Pictures Using The Lcd Monitor - Pentax Digibino DB 100 Operating Manual

e03_db100_33e.qk 4/16/02 4:35 PM Page 20

Taking Pictures

¡
Lower the slide lever.
The lens barrier opens.
You hear a confirmation beep, the status lamp blinks red
and green, and the power turns on.
™
Raise the LCD monitor.
£
While looking through the binoculars, turn the central focusing
wheel to adjust the focus.
¢
Press the shutter release button.
You will hear a confirmation beep and the status lamp will glow green for about
one second.
The image will be recorded in the memory.
When the status lamp turns off, you can take the next picture.
When you move the slide lever up and close the lens barrier, the power turns off.
Caution
If the shutter speed is slower than 1/125 second, the status lamp will blink red (camera shake
alarm) after taking the picture. Check the recorded image on the LCD monitor.
20

Quick Start

Slide lever

Taking Pictures Using the LCD Monitor

¡
Lower the slide lever.
The lens barrier opens.
™
Raise the LCD monitor.
£
Press the DISPLAY button.
The LCD monitor turns on and displays images through
the taking lens.
¢
While looking through the LCD monitor, turn the central focusing
wheel to adjust the focus.
Look through the binoculars to confirm the focus.
∞
Press the shutter release button.
The image is displayed for two seconds (Instant Review).
When the image seen through the taking lens is displayed on the LCD monitor,
you can take the next picture.
When you move the slide lever up and close the lens barrier, the power turns off.
21