On Screen Messages - Panasonic Viera TX-P55VT30B Operating Instructions Manual

On screen messages

Message
All tuning data will be erased
Are you sure ?
Are you sure you want to
delete this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
External (USB-HDD / SD
Card) Recording Due to Start
Faulty dish
Feature not available.
Feature not available.
Press OK to view how it works.
Found new software
∗∗∗
version .
Press OK to start update
(may take over 40 mins) or
press EXIT to ignore and
you can update when TV is
in standby
Invalid operation - Please
check settings and
connections.
Invalid system time. Please
exit !
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check
time display on Banner
Max. number of timers
already set !
New channels found!
Press OK to update
channel list.
Press EXIT to ignore.
No channel found.
Please check aerial or
local signal availability.
Press OK to start Auto Setup.
124
•
[Shipping Condition] will erase all tuning data
•
Confirm correct operation.
•
Confirm correct operation.
•
The signal is weak. Check the aerial is plugged in properly. It may
be necessary to have an aerial installer check the signal and aerial
alignment.
•
Reset channels. (p. 52, 53)
•
The selected channel is locked in Child Lock (p. 64). You must enter
the PIN number before the channel will be displayed.
•
This message will appear 2 minutes before timer programming
event for external, USB HDD or SD Card recording due to start.
•
The satellite cable might be short-circuited or there might be
connection problems of the cable. Check the cable and connection
and then turn the TV Off with the Mains power On / Off switch, and
turn it On again.
•
If the message still persists, it may be necessary to consult a dish
installer for checking the dish and cable.
•
It is not possible to record from COMPONENT or HDMI. Connect
the recorder to the TV using a fully wired SCART cable for recording
from the TV tuner.
•
Confirm Q-Link or VIERA Link settings
•
The selected feature on VIERA TOOLS is not available. Press the
OK button to view the demonstration to explain how to use it.
•
There is a new software available.
•
Check the Q-Link or VIERA Link connection and setting
(p. 102 - 105)
•
Cannot get the time information and cannot edit Timer Programming
screen. Check the connection of the RF cable.
•
Cannot get the time information. If there is no time displayed on the
Information banner, check the connection of the RF cable.
•
The maximum number of timer programming events is 15.
•
There may be new channels available.
•
This message will appear each time a change is made by the
broadcasters. This message can be deactivated by setting [New
Channel Message] to Off in [DVB Tuning Menu].
Selecting OK will perform [Update Channel List].
•
Follow the on screen instructions.
•
Please also refer to p. 121.
•
If channels are still not found, consult your local Panasonic dealer.
Meaning / Action
(p. 102 - 105)
(p. 67)