On Screen Messages - Panasonic Viera TX-L32E31B Operating Instructions Manual

Problem
The remote control
does not work or is
intermittent
Parts of the TV become
hot
The LCD panel moves
slightly when it is
pushed with a finger
Clattered sound might
be heard
Overcurrent error
message appears
An error message
appears

On screen messages

Message
All contents will be lost.
Are you sure to delete this device?
All tuning data will be erased
Are you sure ?
Are you sure you want to delete
this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
External (USB-HDD) Recording
Due to Start
Feature not available.
Feature not available.
Press OK to view how it works.
Found new software version
Press OK to start update (may
take over 40 mins) or press EXIT
to ignore and you can update
when TV is in standby
Invalid operation - Please check
settings and connections.
Invalid system time. Please exit !
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check time
display on Banner
Max. number of timers already
set !
102
•
Are the batteries installed correctly?
•
Has the TV been switched On?
•
The batteries may be running low. Replace them.
•
Point the remote control directly at the front of the TV (within about 7 m and a 30
degree angle of the front of the TV).
•
Situate the TV so that sunshine or other sources of bright light do not shine on the TV's
remote control signal receiver.
•
Temperature rises of parts of the front, top and rear panels will not pose any problems in
terms of performance or quality of the TV.
•
There is some flexibility around the panel to prevent damage to the panel.
•
The panel might move slightly when it is pushed with a finger, and clattered sound
might be heard. This is not a malfunction.
•
The connected USB device might cause this error. Remove the device and turn the TV
Off with Mains power On / Off switch, then turn it On again.
•
Check if foreign objects are inside the USB port.
•
Follow the message's instructions.
•
If the problem persists, contact your local Panasonic dealer or the authorized Service Centre.
•
Once you format the USB HDD, all the recorded programme will be erased.
•
[Shipping Condition] will erase all tuning data
•
Confirm correct operation.
•
Confirm correct operation.
•
The signal is weak. Check the aerial is plugged in properly. It may be necessary to
have an aerial installer check the signal and aerial alignment.
•
Reset channels.
•
The selected channel is locked in Child Lock (p. 47). You must enter the PIN number
before the channel will be displayed.
•
This message will appear 2 minutes before timer programming event for external
(USB HDD) recording due to start.
•
It is not possible to record from COMPONENT or HDMI. Connect the recorder to the
TV using a fully wired SCART cable for recording from the TV tuner.
•
Confirm Q-Link or VIERA Link settings
•
The selected feature on VIERA TOOLS is not available. Press the OK button to view
the demonstration to explain how to use it.
∗∗∗
.
•
There is a new software available.
•
Check the Q-Link or VIERA Link connection and setting
•
Cannot get the time information and cannot edit Timer Programming screen.
Check the connection of the RF cable.
•
Cannot get the time information. If there is no time displayed on the Information
banner, check the connection of the RF cable.
•
The maximum number of timer programming events is 15.
Actions
(p. 7)
Meaning / Action
(p. 40)
(p. 81 - 84)
(p. 49)
(p. 81 - 84)