Table of Contents
Advertisement
TG5511-5521FX(e).book Page 37 Thursday, April 22, 2010 1:24 PM
Receiving a message
When an SMS message is received:
– "Receiving SMS Message" is
displayed.
– a tone is heard (if the handset ringer is
turned on).
– h is displayed with the total number
of new (unread) SMS messages.
Reading a received message
1
8 i {#}{3}{5}{0}
2
{V}/{^}: "Receive List" i M
3
{V}/{^}: Select a message.
L Messages which have already
been read are indicated by a "Q",
even if they were read using
another handset.
L To erase a message, press W.
i {V}/{^}: "Yes" i M
4
Press M to read the message
content.
Note:
L To call the message sender, press
{C}.
Replying to a message
1
While reading a received message,
press 8.
2
{V}/{^}: "Reply" i M
3
Enter a message (page 47). i
M
4
Edit the destination phone number if
necessary. i M
5
Continue from step 5, "Writing and
sending a new message", page 36.
Editing/forwarding a message
1
While reading a received message,
press 8.
SMS (Short Message Service)
2
{V}/{^}: "Edit Message" i M
3
Continue from step 3, "Writing and
sending a new message", page 36.
Erasing received messages
1
While reading a received message,
press 8.
2
{V}/{^}: "Erase" i M
L To erase all messages, select
"Erase All". i M
3
{V}/{^}: "Yes" i M i {ic}
Storing the sender's number
in the phonebook
1
While reading a received message,
press 8.
2
{V}/{^}: "Add Phonebook" i
M
3
To store the name, continue from
step 2, "Adding entries", page 21.
Editing the sender's number
before calling back
1
While reading a received message,
press 8.
2
{V}/{^}: "Edit & Call" i M
3
Edit the number. i {C}
Other settings
Storing the PBX line access
number (for PBX users only)
Store your PBX line access number (4
digits max.) so that SMS messages are
sent properly. When sending SMS
messages to entries in the phonebook or
redial list, the PBX line access number is
deleted. The default setting is "Off".
37
Advertisement
Table of Contents
