Table of Contents
Advertisement
TG5511-5521FX(e).book Page 42 Thursday, April 22, 2010 1:24 PM
Answering System
Erasing all messages
1
8 i {#}{3}{2}{5}
2
{V}/{^}: "Yes" i M i {ic}
Remote operation
Using a touch-tone phone, you can call
your phone number from outside and
access the unit to listen to messages or
change answering system settings.
Remote access code
A 3-digit remote access code must be
entered when operating the answering
system remotely. This code prevents
unauthorised parties from listening to
your messages remotely.
Important:
L In order to operate the answering
system remotely, you must first set a
remote access code.
1
8 i {#}{3}{0}{6}
2
To turn on remote operation, enter
the desired 3-digit remote access
code.
3
M i {ic}
Deactivating remote operation
Press {*} in step 2 on "Remote access
code", page 42.
L The entered remote access code is
deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts,
enter your remote access code.
42
L The unit announces the number of
new messages.
3
Enter remote commands.
4
When finished, hang up.
Note:
L You can also leave a message just as
any outside caller can. After the
greeting message starts, press {*} to
skip the greeting message and record
your message after the beep.
Remote commands
Key
Operation
Repeat message
{1}
(during playback)
Skip message
{2}
(during playback)
Play new messages
{4}
Play all messages
{5}
Play greeting message
{6}
Record greeting message
{7}
Stop recording
{9}
Stop playback
Turn answering system off
{0}
Erase currently playing
{*}{4}
message
Erase all messages
{*}{5}
Reset to a pre-recorded
{*}{6}
greeting message (during
greeting message
playback)
End remote operation
{*}{#}
(or hang up)
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
*1
Advertisement
Table of Contents
