Registering A Handset To The Base Unit - Panasonic KX-TG8161E Operating Instructions Manual

Programming
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
(middle soft key) #130
2
Base unit:
Proceed with the operation for your
model.
n KX-TG8151 series: page 3
Press and hold M
seconds. (No registration tone)
n KX-TG8161 series: page 3
Press and hold M
seconds, until the registration tone
sounds.
R If all registered handsets start ringing,
press M N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3
Handset:
a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a
R If you forget your PIN, see page 49.
R When the handset has been registered
successfully,
Note:
R While registering, "Base in
registering" is displayed on all
registered handsets.
R When you purchase an additional handset,
refer to the additional handset's installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
34
TG8151_61E(en)_1220_ver021.pdf
N for about 5
N for about 5
is displayed.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
34
the same base unit. This allows the handset to
end its wireless connection with the system.
1
(middle soft key) #131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a
3
MbN: "Yes" a
R A confirmation tone sounds.
R The handset does not beep when
cancelling its own registration.
4
M N
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
(middle soft key) #138
2
MbN: Select the desired setting. a
a M N
Note:
R After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
2011/12/20 18:50:48
is displayed.