Registering A Unit - Panasonic KX-TG7521E Operating Instructions Manual

TG7521E(e).book Page 30 Friday, January 22, 2010 8:46 AM
Programming
■ From the caller list:
1
{<} (y)
2
{V}/{^}: Select the entry to be
barred. i M i I
3
{V}/{^}: "Caller Barred" i
M
4
{V}/{^}: "Yes" i M i
{ic}
■ By entering phone numbers:
1
1 i {#}{2}{1}{7} i m
2
Enter the phone number (24
digits max.). i M
L To erase a digit, press ^.
3
{ic}
Viewing/editing/erasing bar call
numbers
1
1 i {#}{2}{1}{7}
2
{V}/{^}: Select the desired entry.
L To exit, press {ic}.
3
To edit a number:
~ i Edit the phone number.
i M i {ic}
To erase a number:
W i {V}/{^}: "Yes" i M
i {ic}
Note:
L When editing, press the desired dial
key to add, ^ to erase.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, see page 53.
1
1 i {#}{1}{3}{2}
2
Enter the current 4-digit base unit
PIN (default: "0000").
30
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
3
Enter the new 4-digit base unit PIN.
i M i {ic}

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when "Auto" is selected on
base unit (page 31), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a "radio
cell".
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, _ is displayed even when