Changing The Handset Name - Panasonic KX-TG7521E Operating Instructions Manual

TG7521E(e).book Page 29 Friday, January 22, 2010 8:46 AM
Note:
L To correct a digit, press {<} or {>} to
move the cursor to the digit, then
make the correction.
Changing the start and end time
1
1 i {#}{2}{3}{7}
2
Continue from step 3, "Turning night
mode on/off", page 28.
Setting the ring delay
This setting allows the handset to ring
during night mode if the caller waits long
enough. After the selected amount of
time passes, the handset rings. If you
select "No Ringing", the handset
never rings during night mode.
1
1 i {#}{2}{3}{9}
2
{V}/{^}: Select the desired setting.
i M i {ic}
Note:
L When the answering system answers
the call, this feature does not work.
Selecting categories to bypass night
mode
1
1 i {#}{2}{4}{1}
2
{V}/{^}: Select your desired
categories. i t
L "Q" is displayed next to the
selected category numbers.
L To cancel a selected category,
press t again. "Q" disappears.
3
M i {ic}
Note:
L You can also select the categories in
step 2 as follows:
Press {1} to {9}. i M

Changing the handset name

Each handset can be given a
customised name ("Bob", "Kitchen",
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programming
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is "Off". If
you select "On" without entering any
handset name, "Handset 1" to
"Handset 6" is displayed.
1
1 i {#}{1}{0}{4}
2
Enter the desired name (max. 10
characters; page 48).
L If not required, go to step 3.
3
M
4
{V}/{^}: Select the desired setting.
i M 2 times
5
{ic}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
Important:
L When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 34) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L You must store the phone number
with an area code in the call barred
list.
29