Taking Pictures Using The Remote Control Unit (Optional) - Pentax Optio WG-2GPS Operating Manual

• With j, you can continue shooting until the memory capacity of the SD
Memory Card or built-in memory is full.
• The interval of j varies according to the [Recorded Pixels] and [Quality
Level] settings.
• The focus, exposure and white balance are locked with the first shot.
• When the Face Detection function is activated (p.69), it works only when
taking the first shot.
• The Blink Detection function works only for the last shot.
• The number of recorded pixels is fixed at f/
shooting mode is set to
to V.
Taking Pictures Using the Remote Control Unit
(Optional)
You can use the remote control (optional) to take pictures while you are away
from the camera.
The shutter will be released after about three seconds when the shutter release
i
button on the remote control unit is pressed.
The shutter will be released immediately when the shutter release button on
h
the remote control unit is pressed.
1
Press the four-way controller (2) in A mode.
The [Drive Mode] screen appears.
2
Use the four-way controller (45) to select i and press the
four-way controller (3).
3
Use the four-way controller (45)
to select i or h and press the
4 button.
The self-timer lamp begins to blink slowly
and the camera is ready to take a picture
with the remote control.
When the camera detects a person's face,
the Face Detection function is activated
and the face detection frame appears (p.69).
(Report), the number of recorded pixels is set
MENU MENU MENU
Cancel Cancel Cancel
in c mode. When the
Drive Mode Drive Mode Drive Mode
Remote Control Remote Control Remote Control
OK OK OK
OK OK OK
3
83