Saving The Settings (Memory) - Pentax Optio WG-2GPS Operating Manual

Saving the Settings (Memory)

The Memory function is for saving the current camera settings when the camera
is turned off.
For some camera settings, the Memory function is always set to O (On) (the settings
are saved when the camera is turned off), while for others you can choose on or off
(to choose whether the settings are saved or not when the camera is turned off). The
items which can be set to O or P (Off) in the Memory function are shown in the table
below. (Items not listed here are always saved in the selected settings when the
camera is turned off.)
If you select O, the settings will be saved in the status they were in immediately before the
3
camera was turned off. If you select P, the settings will be reset to the defaults when the
camera is turned off. The table below also shows whether the Memory default setting for
each item is O or P.
Item
Face Detection
Flash Mode
Drive Mode
Focus Mode
Zoom Position
MF Position
White Balance
Sensitivity
EV Compensation
AE Metering
Digital Zoom
DISPLAY
File No.
120
Description
A Face Detection mode set by using the I
button.
The flash mode set with the four-way
controller (4)
The drive mode set with the four-way
controller (2)
The focus mode set with the four-way
controller (5)
The zoom position set with the W/T button.
The manual focus position set with the four-
way controller (23)
The [White Balance] setting on the
[A Rec. Mode] menu
The [Sensitivity] setting on the
[A Rec. Mode] menu
The [EV Compensation] setting on the
[A Rec. Mode] menu
The [AE Metering] setting on the
[A Rec. Mode] menu
The [Digital Zoom] setting on the
[A Rec. Mode] menu
The information display mode set with the
4/W button
If a new SD Memory Card is inserted when
set to O (On), file numbers are assigned
sequentially.
Default
Page
setting
p.69
P
p.90
O
p.81 -
P
p.84
p.91
P
p.63
P
p.92
P
p.98
P
p.100
P
p.101
P
p.99
P
p.65
O
p.25
P
⎯
O