Battery Installation; Battery Charge - Panasonic KX-TCD320E Operating Instructions Manual

TCD320E(e).book Page 12 Friday, January 7, 2005 10:01 AM
Preparation
of the adaptor may cause it to become
disconnected.
L The unit will not work during a power
failure. We therefore recommend you also
connect a standard telephone to the same
telephone line using a T-adaptor. Your
Panasonic sales shop can offer you more
information about connection possibilities.

Battery installation

1
Insert the batteries negative (T)
terminal first.
2
Close the handset cover.
Note:
L Use only rechargeable batteries (page 7).

Battery charge

Place the handset on the base unit for
about 7 hours before initial use.
When charging, i and battery strength
icon are alternately shown on the display.
12 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
When the batteries are fully charged, 1
flashes.
Note:
L It is normal for the handset to feel warm
during charging.
L It takes 7 hours to fully charge the
batteries, however, you can use the
handset before the batteries are fully
charged.
L Clean the charge contacts (page 9) of the
handset and base unit with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
Battery strength
Battery icon Battery strength
High
1
Medium
2
Low
3
When flashing: Needs
to be charged.
Note:
L When 3 flashes, recharge the handset
batteries. 3 will continue to flash until
the batteries have been charged for at
least 15 minutes.