Error Messages; Reports; Error Messages Reports - Panasonic KX-FLM600E Operating Instructions Manual

Error Messages

Reports!

If your unit cannot send a fax, check the following.
—The number you dialled is correct.
—The other party's machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the sending and journal
reports (p. 45, 46).
Communication message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
MEMORY FULL
NO DOCUMENT
OTHER FAX NOT RESPOND
PC FAIL OR BUSY
PRESSED THE STOP KEY
TOP COVER WAS OPENED
FRONT PANEL WAS OPENED
OK
100
Error
code
41–72 ≥A transmission or reception error occurred. Try again or check
FF with the other party.
— ≥The document is jammed. Remove the jammed document
(p. 112).
≥A sheet of paper was inserted in the paper tray while scanning
the document. Remove the paper from the paper tray.
54, 59 ≥A transmission or reception error occurred because of a problem
70 with the other party's fax machine. Check with the other party.
— ≥The document was not received due to memory being full.
— ≥The document was not fed into the unit properly. Reinsert the
document and try again.
40 ≥The other party's fax machine was busy or ran out of recording
paper. Try again.
≥The document was not fed properly. Reinsert the document and
try again.
≥The other party's fax machine rings too many times. To send a
fax manually, dial the number, confirm the fax tone, and press
(START/SET/COPY).
≥The other party's machine is not a facsimile. Check with the
other party.
≥The number you dialled is not in service.
— ≥The PC cannot control the fax functions.
The printer cable is not connected correctly, or the software is
not running on the PC (p. 71–73).
— ≥(STOP) was pressed and fax communication was cancelled.
— ≥The top cover was opened. Close it and try again.
— ≥The front panel was opened. Close it and try again.
— ≥Fax communication was successful.
Cause & Remedy