Stamp - Konica Minolta 7222 User Manual

Copying Image in the Centre of Copy Paper (AUTO Layout) (continued)
• Non-Image Area Erase will be selected automatically.
• When using the Dual Page with this function, the original smaller than the
selected paper size will be printed in the centre of the copy paper without
image division performed.
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic Screen.
• APS and AMS are automatically released, and 1.00 (100%) is selected
as a magnification ratio.
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE DOWN
on the platen glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
DO NOT close the RADF or platen cover when Non-Image Area Erase is
selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [START].
When the finisher / paper exit / inner tray capacity is exceeded due
to the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if the lighting is directly
over the platen glass. In this case, consult your service representative about
an appropriate place for installation.
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
OHP
Interleave
Image Insert
Dual Page
Flip Side 2
Non-Image
Area Erase
Reverse
Image
Repeat
Frame/Fold
Erasure
AUTO
Layout
9
Applications
Image Shift
Reduce &
Shift

Stamp

Overlay
9-41