Setup; Charging The Battery - Panasonic HDC-SD5 Operating Instructions Manual

Setup

Charging the battery

When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
≥ Connect the battery to an AC adaptor to
recharge it.
≥ If the DC cable is connected to the AC
adaptor, then the battery will not charge.
Remove the DC cable from the AC adaptor.
≥ Refer to page 25 concerning batteries that
can be used with this unit.
1
Connect the AC cable to the AC
adaptor and the AC outlet.
≥ Remove the DC cable beforehand.
2
Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
≥ The output plug of the AC cable is not
completely connected to the AC adaptor
socket. As shown in A, there is a gap.
ª Charging lamp
Lights up:
Charging
Goes off:
Charging completed
Flashing:
Make sure that the terminals of the battery or the
AC adaptor are not exposed to dirt, foreign
objects or dust, then reconnect them properly.
Disconnect the AC cable from the AC outlet
when you remove dirt, foreign objects or dust on
the terminals of the battery or the AC adaptor.
If the charging lamp is still flashing, something
may be wrong with the battery or AC adaptor.
Contact your dealer.
A
≥ Battery charging time (l 25)
≥ We recommend using Panasonic batteries
(l 14, 25).
≥ If you use other batteries, we cannot guarantee
the quality of this product.
Setup
23
VQT1H64