Using Sound Effects; Usb - Panasonic SC-PM5DB Operating Instructions Manual

Using sound effects

Changing the sound Changing the sound
quality: Preset EQ quality: Preset EQ
Press [PRESET EQ] repeatedly to select
your desired setting.
HEAVY
Setting Effect
HEAVY Adds punch to rock
CLEAR Clarifi es higher frequencies
SOFT For background music
VOCAL Adds gloss to vocal
FLAT No effect
Changing the sound Changing the sound
quality: Bass or treble quality: Bass or treble
Enable you to enjoy the lower or higher pitch sound.
1
Press [BASS] or [TREBLE] to select your
desired setting
2
Press [4/1] or [¡/¢] to adjust the
level.
By main unit only
1
Press [BASS/TREBLE] repeatedly to
select your desired setting.
2
Press [4/1] or [¡/¢] to adjust the
level.
Note:
The level of the pitch is between -4 to +4.
Enhancing the stereo sound: Enhancing the stereo sound:
Surround sound Surround
Enable you to add natural width and depth to the
stereo sound.
To activate
Press [SURROUND] to display "
indicator.
To cancel
Press [SURROUND] again to clear "
indicator.
Note:
• Surround sound is less discernible when listening
through headphones.
• If interference in FM stereo reception increases,
cancel the surround-sound effect.
Changing the sound Changing the sound
quality: RE-MASTER quality: RE-MASTER
MP3
This feature reproduces the frequencies lost during
recording to give you a sound closer to the original.
16
Press [RE-MASTER] repeatedly to select either
"ON RE-MASTER" or "OFF RE-MASTER".
CLEAR SOFT
FLAT VOCAL
.
BASS TREBLE
Original display
sound

USB

MP3
The USB connectivity enables you to connect and
play MP3 tracks from USB mass storage class.
Typically, USB memory devices. (Bulk only transfer)
Connecting a USB mass storage Connecting a USB mass storage
device device
Preparation
Before connecting any USB mass storage device
to the unit, ensure that the data stored therein has
been backed up.
It is not recommended to use a USB extension
cable. The device connected via the cable will not be
recognised by this unit.
Playing a USB mass storage device Playing a USB mass storage device
1
Reduce the volume and connect the USB
mass storage device to the USB port.
2
Press [6, USB] or [OK] to start play.
Pause play
Stop play
"
Skip tracks
"
Skip album
USB enabled
device
(not included)
Press [6, USB].
Press again to resume play.
Press [7] (stop).
"RESUME" is displayed. The
position is memorised.
Press [6, USB] to resume play.
Press [7] (stop) again to clear the
position.
Press [4/1] or [¡/¢].
Press [5 / ∞, ALBUM] in the play
mode.
Press [5 / ∞, ALBUM] once and
then the numeric buttons in the
stop mode.