To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day if the timer is
on.
•
If you turn off the system and then turn on again while a
timer is in operation, the timer will not stop at the end time.
• "
"
"
"
"
CD
,
USB
and
Sound effects
1
Press [SOUND] repeatedly to select the sound
effect.
2
Press [R, T] to select the setting and then press
[OK].
MY SOUND
PRESET EQ
BASS
TREBLE
D.BASS
SURROUND
Note:
Changed settings will be kept until it is changed again, unless
otherwise indicated.
Saving the sound settings
You can save the current sound effects (up to
3 combinations).
Preparation
Select the sound effects.
1
Press [SETUP] to select "SAVE MY SOUND".
2
Press [R, T] to select a sound setting number and
then press [OK].
"SAVED" is shown.
The new setting replaces the one existing in the same
sound setting number.
To recall the setting
1
Press [SOUND] to select "MY SOUND".
2
Press [R, T] to select the sound setting number
and then press [OK].
10
"
FM
can be set as the music source.
"SOUND 1", "SOUND 2" or
"SOUND 3" (
below)
"HEAVY", "SOFT", "CLEAR",
"VOCAL" or "FLAT"
–4 to +4
–4 to +4
"ON D.BASS" or "OFF D.BASS"
"ON SURROUND" or
"OFF SURROUND"
Others
Auto off
This system automatically turns off when you do not use it
for approximately 20 minutes.
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
This function does not work when you are in radio source or
when a Bluetooth
®
device is connected.
Bluetooth
standby
®
This function automatically turns on the system when you
establish a Bluetooth
connection from a paired device.
®
1
Press [SETUP] repeatedly to select
"BLUETOOTH STANDBY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Software update
Occasionally, Panasonic may release updated software
for this unit that may add or improve the way a feature
operates. These updates are available free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
█ Checking the software version
1
Press [SETUP] repeatedly to select "SW VER."
and then press [OK].
The software version is shown.
2
Press [OK] again to exit.