Maytag MDG6700AWM Installation Instructions Manual page 10

3-WIRE SYSTEM CONNECTIONS
1. Loosen or remove center terminal Mock screw.
2. Connect neutral wire (white or center wire) of power supply cord to the center, silver
colored terminal screw of the terminal block. Tighten screw.
3. Connect the other wires to outer terminal block screws. Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold=
down screw.
3
4
5
1. External ground connector
2. Neutral grounding wire (green/yellow)
3. Center silver-colored terminal block screw
4. Neutral wire (white or center wire)
5. 3/4 in. (1.9 cm) ULqisted strain relief
WARNmNG: If converting from a 4-wire electrical system to a 3=wire, the ground strap
must be reconnected to the terminal block support to ground the dryer frame to the
neutral conductor.
4-W_RE SYSTEM CONNECTmONS
1. Remove center terminal block screw.
2. Connect ground wire (green or bare) of power supply cord to external ground conductor
screw,
3. Connect neutral wire (white or center wire) of power supply cord and appliance ground
wire (green with yellow stripes) under central screw of the terminal block.
4. Connect the other wires to outer terminal block screws. Tighten screws.
5. Tighten strain relief screws.
6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down
screw.
I
............... _ ........ 4
6
1. External ground connector
2. Green or bare copper wire of power supply cord
3. 3/4 in. (1.9 cm) ULqisted strain relief
4.Center silver-colored terminal block screw
5 Grounding wire (green/yellow)
6. Neutral wire (white or center wire)
EXPORT MODELS
Refer to last page of installation instructions.
10