Table of Contents
Advertisement
OVERVIEW
The CAT111 Orbital Sander is ideal for use in the automotive industry or any
task of smoothing wood, fibreglass or body filler. The sander features a
balanced ball-bearing design, rear exhaust & automatic throttle release. The
CAT111 sander holds standard 93 x 232mm sanding sheets which are
available from your CLARKE dealer.
Unpack and lay out the components, checking against the following list. Any
damage or deficiency should be reported to your CLARKE dealer
immediately.
•
Orbital Sander
•
Male screw-in adaptor
•
Bottle of Airline Oil
•
Operators Manual (this document)
ASSEMBLY
1. Remove the plastic blanking plug from the connection port of the sander .
2. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done
regardless of whether or not a lubricated air supply is to be used.
3. Connect a suitable hose to
the sander as shown. Use the
screw-in adaptor supplied if
required.
4. Connect the other end of the
hose to the compressor.
(A whip hose with a quick
fit coupling is available
from your CLARKE dealer).
5. Turn on the air supply and
check for air leaks. Rectify
any found before proceding.
Your sander is now ready for
use.
7
Advertisement
Table of Contents
