Table of Contents
Advertisement
OPERATING INSTRUCTIONS
IMPORTANT: Only use sanding sheets designed for use with a rectangular
orbital sander;-pre-cut sheets (93 x 232mm) are available from your
CLARKE dealer.
1 Attach a sanding sheet to the
base of the sander using the
spring-loaded clips at each end
of the base as in Fig 1.
• Ensure the sanding sheet is
correctly aligned with the sander
and pulled tight enough to avoid
any creasing.
2. Place the sander on the
workpiece and press down on
the trigger to start the sander.
3. Adjust the operating speed if
required, by twisting the air
regulator as in Fig 2.
4. Release pressure from the trigger
to stop the sander.
5. Always ensure the sander has
stopped before putting it down.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released from the air line.
2. Once the pressure has been released, disconnect the airline hose from
the sander.
STORAGE
1. Store the sander safely in its box in a dry, secure environment.
2. If the sander is not to be used for longer than 24 hours, run a few drops of
CLARKE airline oil into the air inlet and run the tool for a few seconds to
ensure that the oil has been well distributed throughout the sander.
3. When storing, ensure the blanking plug is replaced at the airline
connection port once the airline has been disconnected.
8
Fig 1
Fig 2
Advertisement
Table of Contents
