Maytag MGD4200BG0 Installation Instructions Manual page 19

Reverse door swing round-shaped door - double handle
1, Remove door from dryer
® ®
®
iMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a TORX® T25 screwdriver, remove the 4 screws
securing the door hinge to the dryer and lift up and out to
remove the door. Place the door on a soft towel or other
non-scratch surface. Reinstall the 4 screws in the holes.
2. Move the door strike
®
®
®
®
® ®
® ®
Using a TORX T25 screwdriver, remove the 2 screws securing
the door strike to the door frame of the dryer. Rotate the
strike 180 ° and attach to the opposite side of dryer door
frame, as shown.
A
3, Remove inner door from outer door
.... %,.¸¸ ......
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
4. Remove hinge and latch
Latch
Hinge
Using a TORX T25 screwdriver, remove the 3 TORX screws
securing the latch plate and latch backing plate and the
5 screws holding the hinge assembly in place.
19