Maytag MGD4200BG0 Installation Instructions Manual page 16

2. Move the door strike
®
®
®
®
®
®
®
®
Using a TORX ® T25 screwdriver, remove the 2 screws
securing the door strike to the door frame of the dryer. Rotate
the strike 180 ° and attach to the opposite side of dryer door
frame, as shown.
f
A
_. Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
m
Remove outer window assembly
from trim ring
Fig. A
Fig. B
Using a Phillips screwdriver, remove the 2 screws from the
outer window retainer and rotate the outer window assembly
clockwise until the square notches line up with the 4 tabs
on the trim ring indicated with arrows in the figure A above.
Then lift out the outer window and retainer up and off the trim
ring and set aside (B).
16