Installation - KitchenAid KUDS30IXBL0 Installation Instructions Manual

plastic
button _----
If securing with a side attachment, check that sides of door
do not rub against the screw heads. If they do, dishwasher
must be re-centered. When dishwasher is properly centered,
replace plastic buttons.
Remove towel from dishwasher. Reinstall the lower
dishrack.
If needed, see website for animated representation
of this step. Visit www.kitehenaid.eom/anehoring under
FAQ tab.
iiii _ii_iii ii_i i_iiiiiiiiii_
Complete Installation
Check that grounding clip is attached to the lower panel.
Position the lower panel behind the access panel. On some
models there is insulation on the access panel which must
fall behind the insulation on the lower panel.
Hold the two panels together and place them against
dishwasher leg. Using a Philips or 1/4" screwdriver, reinstall
the screws through the holes in the access panel and the
slots in the lower panel.
Check that the lower edge of the lower panel contacts
the floor. Adjust if necessary.
Tighten access panel screws.
24