KitchenAid KUDS30IXBL0 Installation Instructions Manual page 16

Attach outerpanel toback ofcustomer-supplied custom
panel withthefour#10-16 x 3/8"hexhead screws s upplied
intheliterature p ackage. Attach thehandle. Thehandle
should becentered o nthefrontofthecustomer-supplied
custom panel i nthearea shown.
IMPORTANT: Screw heads mustbeflushwithbackof
customer-supplied custom panel.
i
R edges
3 screws
each side Customer-supplied
panel
J
Attach the panel assembly to the door by reinstalling the
three screws on each side; do not tighten completely. This
reinstallation of the three screws will hold the panel
assembly in place on the door frame.
top
edges
Drill through
these holes
Customer-supplied
panel
i,,_
Align the top edge of the customer-supplied custom
panel with the top of the console.
Drill two 3/32" pilot holes 1/2" (13 mm) deep, into the
customer-supplied custom panel, through the holes in the
top corners on the inner panel, as shown.
16
top
edges
)rill through
these holes
Customer-supplied
panel
Install the two #8-18 x 1 3/8" screws from
the literature package in the top corners of the inner
panel. Tighten the six side screws reinstalled in Step 6.
Install Custom Panel - Option 2
(Models KUDCO21V and KUDS2OIV)
All models require an accessory option to attach custom
panels. Kit Number 8171555 (black), 8171556 (white) or
8171557 (biscuit) are available. To order, call customer
service at 1-8OO-444-1230.
NOTE: A custom full front panel must weigh no more
than 14 Ibs (6.3 kg) and must be made to specific
dimensions. It is recommended that a cabinetmaker cut
the custom panel because of the precise dimensions
needed.
IMPORTANT: Use a moisture resistant sealer on both
sides and all edges of the panel to avoid damage from
humidity.
NOTE: These dimensions are for frameless custom panel
models with a 4" (10.2 cm) console only.
C usto m pa n eI insta IIat io n -
1J Dishwashers with control 1
panel on the front | ................
/
23 3/8" /'_1"_,25 29/32" (65.8 cm)
(65.8 cm) _____.._
mm)
(3.2 mm)
mm)
*This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
With a TORX _ screwdriver, remove three screws from
both sides, as shown; hold the outer panel up while
removing the screws. Save screws for reinstallation.