Electricity Supply; Water Supply - Hoover HNL 9136 Instruction Book

40002168.qxd 20/10/2004
You may be
charged for a
service call if a
problem with
your machine is
caused by
incorrect
installation.
If the mains
cord on this
appliance is
damaged, it
must be
replaced by a
special cord
which is ONLY
obtainable from
the GIAS spares
service. It must
be installed by
a competent
person.
Call G G IAS
01204 5 5 56111
8
19:14 Page 8

Electricity supply

Washing machines are supplied to operate at a
voltage of 240V, 50 Hz single phase. Check that
the supply circuit is rated to at least 13A.
The plug is already equipped with a 13A fuse
which is BS 1362 ASTA approved. Any
replacement must be the same rating and
specification. If t t he f f use c c over i i s l l ost, d d o n n ot u u se
the p p lug u u ntil i i t i i s r r eplaced.
Electricity can be extremely dangerous.
This washing machine must be earthed.
The socket outlet and the plug on the appliance
must be of the same type.
Do not use multiple adapters and/or extension
leads.
The wires in the mains lead are coloured in
accordance with the following codes:
Blue
Brown
Green and Yellow
CE Appliance complies with European Directive
89/336/EEC, 73/23/EEC and subsequent
amendments.

Water supply

● The cold water pressure should be between
0.5 and 8 bar (0.05-0.8 Mpa).
● Do not connect the machine to a single
outlet instantaneous water heater.
● The water supply tap should be accessible
when the machine is installed.
● Before connecting the fill hose, check that
the water is running from the water supply
tap to be used.
NEUTRAL
LIVE
EARTH