Error Codes - Minolta Di181f User Manual

Troubleshooting
7.2

Error Codes

Error
Problem
code
10 No answer
11 The number dialled is a standard
telephone number.
20 The transmission was interrupted by
the recipient.
21 Error during 1 page TX.
25 Memory error
26 ECM error
29 The transmission was interrupted or
the machine was disconnected from
the mains.
30 - 36 Poor print quality
40 The receiving fax machine has run out
of paper or has insufficient memory.
41 Polling reception failed because
document had not been fed correctly
into the feeder.
44 ECM error
45 No loop current.
46 Other location busy.
47 Rings fail to be recognised.
48 The other location does not respond.
49 Engaged tone is heard before the
number has been dialled.
50 - 60 A connection cannot be established
due to the poor telephone line.
71 Wrong password
72 The receiving fax machine does not
have the polling function.
75 A polling signal has been received, but
the machine is not set to polling RX.
79 The receiving fax machine does not
have the mailbox function.
FE, FF
Rev. /
Solution
Check the telephone line. Ensure the
receiving fax is operational.
Enter the fax number.
Resend.
Ensure that enough memory is
available. Delete files which are no
longer needed.
Call the technical service.
Reduce the modem speed to 9600 bps.
Inform the recipient.
Inform the recipient.
Call the technical service.
Check the telephone line.
Resend later.
Check the telephone line.
Inform the recipient.
Check the telephone line. Resend later.
Reduce the modem speed to 9600 bps.
Check the sub-address ID and the
password for selective polling.
Set the machine to polling RX.
Switch the machine off and then on. If
the problem persists, contact the
technical service.
Di181f
7
7-61