Installation Precautions - Mita DP-2800 Instruction Handbook Manual

Installation Precautions

Environment
CAUTION
• Avoid placing the printer on or in locations which are unstable or
not level. Such locations may cause the printer to fall down or fall
over. This type of situation presents a danger of personal injury
or damage to the printer. ................................................................
• Avoid locations with humidity or dust and dirt. If dust or dirt
become attached to the power plug, clean the plug to avoid the
danger of fire or electrical shock. ...................................................
• Avoid locations near radiators, heaters, or other heat sources, or
locations near flammable items, to avoid the danger of fire. ..........
• To keep the printer cool and facilitate changing of parts and
maintenance, allow access space as shown below.
Leave adequate space, especially around the rear cover, to allow
air to be properly ventilated out of the printer.
Chapter 1 Safetygaurds and Installing the Page Printer
Other precautions
• Adverse environmental conditions may affect the safe operation and
performance of the printer. Install in an air-conditioned room
(recommended room temperature: around 20°C, humidity: around 65%RH)
and avoid the following locations when selecting a site for the printer.
. Avoid locations near a window or with exposure to direct sunlight.
. Avoid locations with vibrations.
. Avoid locations with drastic temperature fluctuations.
. Avoid locations with direct exposure to hot or cold air.
. Avoid poorly ventilated locations.
. Ammonia or other harmful fumes. (If you are planning to fumigate the
room, or make liberal use of insecticide, remove the printer first!)
. Low air pressure, e.g., located more than 2000 meters (6500 feet) above
sea level.
• The printer will work best if it is installed in a location that is:
. Near the computer
If the parallel interface is used to connect the printer to the computer, the
connecting cable should be shielded type and not be longer than 3
meters (10 feet).
. Level and well supported
Place the printer on a sturdy table or desk. Do not place the printer on an
unstable cart, stand, or table. The printer may fall, causing injury, or
serious damage to the printer.
1-3