Mita DP-2800 Instruction Handbook Manual page 162

Message
Battery error
MEMORY CARD
Format error
MEMORY CARD
MEMORYCARD err ##
Press CONTINUE
Corrective Action
Insert a new battery in the memory card.
This message appears when the printer is in the ready state and the battery in
the memory card is missing or completely dead. Memory card operations are
not possible. Insert a new battery in the memory card.
The memory card requires formatting.
This message appears when the printer is in the ready state and the memory
card is not formatted.
Be sure to format the memory card. (See Chapter 2.)
This message appears when an error occurs during access to the memory
card using the PRESCRIBE ICCD command or from the printer's control
panel. Look at the error code given in place of ## and refer to the
corresponding description given below. Note that only error codes 09 and 11
are displayed due to memory card operations made from the control panel.
01:Data or memory card capacity is too large.
·
This error code appears if an attempt is made to write more than
32 MB of data to a memory card or if the capacity of the memory card
installed in the printer is more than 32 MB. Decrease the data being
written to the memory card to less than 32 MB. Note that only memory
cards of 32 MB and less can be used by this printer.
·
This error code appears when a data name not existing on the memory
card is specified.
Check the data names on the memory card.
02: The memory card does not meet specifications. This memory card cannot
be used by this printer. Insert a memory card which can be used by this
printer. (See "Memory Cards" of Chapter 2.)
03: The memory card is not a JEIDA card. Only JEIDA Ver. 4.2 memory cards
can be used by this printer.
04: The card is an S-RAM or flash card which cannot be used by this printer.
Chapter 5 Troubleshooting
(Continued on next page)
5-13