Troubleshooting - KTM 2008 1190 RC8 USA Owner's Manual

TROUBLESHOOTING

TROUBLESHOOTING 10
Faults
Engine doesn't crank when the electric
starter button is pressed
Engine cranks only if the clutch lever
is pulled
Engine cranks although it is in gear
Engine cranks but doesn't start
Possible cause
Operating error
Battery discharged
Fuse 1, or 6 blown
Main fuse blown
Ignition/steering lock or emergency
OFF switch defective
Safety start system defective
Immobilizer active
EFI control unit not activated
Malfunction of CAN-Bus communica-
tion
Combination instrument defective
A gear is engaged
Safety start system defective
Safety start system defective
Fuse 5 blown
Coupling of fuel hose connection not
joined together
Plug connector of wiring harness oxi-
dized
Fault in fuel injection system
Action
–
Carry out the steps for starting. (
–
Recharge the battery. x
–
Check closed-circuit current.
–
Change the fuses of individual power consumers.
( p. 163)
–
Change the main fuse. (
–
Check the ignition/steering lock.
–
Check the emergency OFF switch.
–
Check the safety start system.
–
Read flash code of immobilizer.
–
Activate the EFI control unit.
–
Check the CAN-Bus communication.
–
Check the combination instrument.
–
Shift into neutral.
–
Check the safety start system.
–
Check the safety start system.
–
Change the fuses of individual power consumers.
( p. 163)
–
Join coupling of fuel hose connection together.
–
Clean plug connector and treat with contact
spray.
–
Read the fault memory with KTM DIA.
203
p. 90)
( p. 159)
x
p. 161)
x
x
x
x
x
x
x
x
x