KTM 2008 1190 RC8 USA Owner's Manual page 152

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Push the rear wheel forward as far as possible and place the chain on the rear sprocket.
–
Pull the rear wheel back and push in the wheel spindle.
700315-01
–
Lay the chain adjuster
–
Position the chain adjuster
–
Tighten nut
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
700316-01
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc and
there is a pressure point.
–
Take the rear of the motorcycle off the work stand. (
–
Check the chain tension. (
on the tensioning screw.

and place it on the tensioning screw.

.

M25x1.5
p. 131)

90 Nm Thread greased
(66.4 lbf ft)
p. 104)
150
.