KTM 2008 1190 RC8 USA Owner's Manual page 212

ENGINE CONTROL FLASH CODE
Input signal of pressure sensor
ambient air too high
Flash code EFI Warning
lamp (MIL)
Possible cause
Input signal from roll angle sen-
sor too low
Input signal from roll angle sen-
sor too high
Flash code EFI Warning
lamp (MIL)
Possible cause
Malfunction in lambda probe
circuit (cylinder 1)
Flash code EFI Warning
lamp (MIL)
Possible cause
Malfunction in lambda probe
circuit (cylinder 2)
Flash code EFI Warning
lamp (MIL)
Possible cause
Malfunction in voltage supply
circuit to EFI control unit
Flash code EFI Warning
lamp (MIL)
Possible cause
–
Check pressure sensor, ambient air.
15 EFI Warning lamp (MIL) flashes 1x long, 5x short
Action
–
Check the roll angle sensor.
–
Check the roll angle sensor.
17 EFI Warning lamp (MIL) flashes 1x long, 7x short
Action
–
Check lambda probe (cylinder 1).
18 EFI Warning lamp (MIL) flashes 1x long, 8x short
Action
–
Check lambda probe (cylinder 2).
24 EFI Warning lamp (MIL) flashes 2x long, 4x short
Action
–
Check voltage supply to EFI control unit.
25 EFI Warning lamp (MIL) flashes 2x long, 5x short
Action
x
x
x
x
x
x
210