Description - Hilti TE7-C Operating Instructions Manual

1.2 Explanation of the pictograms and other
information
Warning signs
en
General Warning:
warning electricity
Obligation signs
Wear eye Wear a hard
protection hat
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use.
Chiseling Chisel position
adjustment

2. Description

2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer with pneumatic hammering mechanism.
The power tools are designed for drilling in concrete, masonry, gypsum board (drywall), wood, plastic and
metal. The power tool can also be used for light chiseling work on masonry and surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use. The power tool may be operated, serviced and repaired
only by authorized, trained personnel. This personnel must be informed of any special hazards that may be
encountered.
16
Revolutions
Wear ear Wear
protection protective
gloves
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation "the
power tool" always refers to the TE 7-C rotary ham-
mer.
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
Drilling Hammer
operating instructions and always refer to it when
without drilling
hammering
making an enquiry to your Hilti representative or
service department.
Type:
Serial no.:
Volts Amps
Watts Alternating
current
Diameter
per minute
Forward
rotation
Hertz Rated speed
under no load
Double Reverse
insulated rotation