Page 1
TE 7-C Bedienungsanleitung Operating instructions Használati utasítás Návod k obsluze Návod na obsluhu Instrukcja obsługi Upute za uporabu Navodila za uporabo Ръководство за обслужване Инструкция по зксплуатации IНСТРУКЦIЯ З ЕКСПЛУАТАЦIЇ Пайдалану бойынша басшылық Instrucţiuni de utilizare Kulllanma Talimatı Printed: 19.05.2014 | Doc-Nr: PUB / 5071207 / 000 / 02...
In these operating instructions, the designation “the Always keep these operating instructions to- power tool” always refers to the TE 7-C rotary hammer. gether with the power tool. Operating controls and parts 1 Ensure that the operating instructions are...
Changes or modifications to the power tool are not permissible. To avoid the risk of injury, use only genuine Hilti accessories and insert tools. Observe the information printed in the operating instructions concerning operation, care and maintenance.
Page 6
Power tool TE‑C CLICK chuck Side handle with depth gauge Operating instructions Hilti toolbox Cleaning cloth Grease 2.8 Using extension cords Use only extension cords of a type approved for the application and with conductors of adequate cross section. The power tool may otherwise loose performance and the extension cord may overheat.
doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Noise and vibration information (measured in accordance with EN 60745‑2‑6 ): Typical A-weighted sound power level 100 dB (A)
Page 9
Use the power tool, accessories and tool bits etc. of the type recommended by Hilti for wood dust in accordance with these instructions, taking into and/or mineral dust together with this tool. Ensure account the working conditions and the work to that the workplace is well ventilated.
Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. Under unfavorable circumstances, dampness or dust adhering to the surface of...
7 Operation 7.1.4 Removing the chuck 6 CAUTION Remove the depth gauge from the side handle and the insert tool from the chuck in order to avoid injury. CAUTION NOTE In the event of the drill bit sticking, the power tool will Set the selector switch to the “Chiseling”...
Keep the power tool, especially its grip surfaces, cloth at regular intervals. Clean the sealing lip by wiping it clean and free from oil and grease. Do not use clean- carefully and then grease it again lightly with Hilti grease. ing agents which contain silicone.
Clean the area of the chuck in contact with dust damaged or when the controls do not function faultlessly. shield and then fit a new dust shield. Press it in firmly If necessary, the power tool should be repaired by Hilti until it engages. Service.
10 Disposal Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or Hilti representative for further information.