Before Use; Operation - Hilti TE7-C Operating Instructions Manual

5.2.5 Personal protective equipment
en
a) The user and any other persons in the vicinity
must wear suitable eye protection, a hard hat,

6. Before use

6.1 Fitting the side handle 2
CAUTION
Remove the depth gauge from the side handle in
order to avoid injury.
1. Disconnect the supply cord plug from the power
outlet.

7. Operation

CAUTION
In the event of the drill bit sticking, the power tool
will pivot about its own axis. Always use the power
tool with the side handle fitted and hold it securely
with both hands so that the resulting opposing force
causes the slip clutch to release in the event of the
drill bit sticking. Use clamps or a vice to hold the
workpiece securely.
7.1 Preparing for use
7.1.1 Adjusting the depth gauge 3
1. Release the side handle clamping band by turning
the handle counterclockwise.
22
ear protection, protective gloves and breathing
protection while the power tool is in use.
2. Release the side handle clamping band by turning
the handle counterclockwise.
3. Slide the side handle clamping band over the
chuck and onto the cylindrical section at the front
end of the power tool.
4. Pivot the side handle into the desired position.
5. CAUTION Check that the clamping band is en-
gaged in the groove provided on the power tool.
Secure the side handle by turning the grip clock-
wise.
6.2 Use of extension cords and generators or
transformers
Please refer to the "Description" section.
2. Pivot the side handle into the desired position.
3. Adjust the depth gauge to the desired drilling
depth.
4. Tighten the side handle securely by turning it
clockwise.
7.1.2 Fitting the insert tool 4
CAUTION
Wear protective gloves when changing the insert tool.
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.