HP 8510w Maintenance And Service Manual page 108

h.
i.
j.
k.
l.
Remove the USB/audio board:
1. Remove the two Phillips PM2.5×4.0 screws (1) that secure the USB/audio board to the base
enclosure.
2. Lift the left side of the USB/audio board (2) until the USB and audio connectors disengage from
the openings in the base enclosure.
3.
Remove the USB/audio board and cables from the base enclosure.
Reverse this procedure to install the USB/audio board.
98 Chapter 4 Removal and replacement procedures
Display assembly (see Display assembly on page
Top cover (see Top cover on page
Speaker assembly (see
Modem module (see Modem module on page
System board (see System board and system board frame on page
84)
Speaker assembly on page
89)
79)
87)
90)