SOYO SY-P4I Fire DRAGON User Manual page 26

Hardware Installation
2. Reset
Plug the Reset push-button cable into the 2-pin Reset header on the
Motherboard. Pushing the Reset button on the front panel will cause the
system to restart the boot-up sequence.
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker
header on the Motherboard.
4. ACPI LED
Connecting the 2-pin ACPI LED cable to the corresponding ACPI LED
header will cause the LED to light whenever the system is in ACPI mode.
The manufacturer has permanently set this Motherboard in ACPI mode due
to most hardware and software compliance to ACPI mode.
Reset Pin Assignment
1
Power Good
Speaker Pin Assignment
+
VCC NC NC
ACPI LED Pin Assignment
+
VCC3MEM
22
SY-P4I Fire DRAGON
GND
_
Speaker out
_
Control Pin