Table of Contents
Advertisement
12. Make Sure
Range
is Level.
Level the range by placing a level horizontally on an oven rack.
Check diagonally from front to back, then level the range by
either adjusting the leveling legs or by placing shims under the
corners of the range as needed.
13. After installation
is complete,
make sure all
controls
are left in the OFF position.
Model
and Serial
Number
Location
The serial plate is located under the lift-up cooktop.
When ordering parts forormaking
inquires about your range,
always be sure to include the model and serial numbers and
a lot number or letter from the serial plate on your range.
Your serial plate also tells you the rating of the burners, the
type of fuel and the pressu re the range was adjusted forwhen
it left the factory.
Before You Call for Service
Check to make sure the house fuses or circuit breakers for
you r range are not blown or open. Refer to the Avoid Service
Checklist and operating instructions in your Owner's Guide. It
may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship
or materials in this appliance.
Refer to the warranty in your Owner's Guide for our
toll-free service number and address. Please call orwrite
if you have inquiries about your range product and/or
need to order parts.
Care,
Cleaning
and Maintenance
Refer to the Owner's Guide for operating
and cleaning
instructions.
If removing the range is necessary for cleaning or maintenance,
shut off gas supply. Disconnect the gas and electrical supply.
If the gas or electrical supply is inaccessible,
lift the unit
slightly at the front and pull out away from the wall. Pull only
as far as necessary to disconnect the gas and electrical
supply. Finish removing the unit for servicing and cleaning.
Reinstall in reverse order making sure to level the range and
check gas connections for leaks. See Anti-Tip Instructions for
properanchoring
instructions.
Gas Conversion
This range was adjusted for Natural or LP/Propane gas, as
specified on the serial plate.
Your regulator is in one of the two locations shown.
Do not remove the Pressure Regulator.
@@
@@
I:rm_ Acce_
Regulatm:
Remove lack F_md,
S_mDr_er,
or
Wmlmer Dr_
Pr_sure
(See Owner_
Guide
Ihsgula_r
_r
instm_jons),
lacatian at
If EquippL, d v_h
r_r6f
PressureRegulator location
la. Convert the Pressure
Regulator
Self-Cleaning
Electric Ignition Models
a.
Unscrew the cap from the pressure regulator. Be sure
spring stays in place.
b.
Turn the cap tothe desired setting (see illustration below).
c.
Replace the cap of the regulator. The letters corresponding
with the type of gas being used should be visible on the
exposed end of the cap.
4 r-AP ,
HOLLOW END
_
TCee'VARDS _1
_
SOUDENDTowARDS
REGULATOR
"_
REGULATOR
FOR NATURAL GAS
FOR LR GAS
lb.Convert
the Pressure
Regulator
Non Self-Cleaning
Electric
Ignition Models
a.
Using a screwdriver or coin, turn the cap counterclockwise
to release from the pressure regulator. Be su re the O-ring
gasket stays in place.
b.
Turn the cap over and place into the slots. Turn clockwise
to lock in position. The letters corresponding with the type
of gas being used should be visible on the exposed end
of the cap.
HOLLOW END
dfCAP_b
SOUD END
TOWARDS
TOWARDS _11_--
_REGULATOR
REGULATOR
FOR NATURAL GAS t._
_
_
FOR L.R GAS
O41_-
O-RING GASKET
(DO NOT REMOVE)
" SPRING
9
Advertisement
Table of Contents
