Page 1
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALIFIED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. if the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
important Notes to the installer Never leave children alone or unattended Read all instructions contained in these installation in the area where an appliance is in use. As children grow, instructions before installing range. teach them the proper, safe use of all appliances. Never leave Remove all packing material from the oven compartments the oven door open when the range is unattended.
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti=Tip Bracket: not available).
Page 4
Connect the range to the gas supply. Level and Position Range- Level range by adjusting the NOTE: To prevent leaks use pipe joint sealant on all male (4) leveling legs with a wrench. Note: A minimum clearance (outside) pipe threads. of 1/8"...
Page 5
the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). Install flare union adapter to external manual shut-offvalve. Attach appliance conduit to flare union on shut-off valve. Make sure service shut-off valve on pressure regulator is in the "ON"...
Page 6
5. Read these electrical connection details first Grounding Instructions then connect electricity to range. The power cord of this appliance is equipped with a Before servicing, disconnect electrical 3-prong (grounding) plug which mates with a standard supply at circuit breaker, fuse or power cord. 3-prong grounding wall receptacle to minimize the possibility of electric shock hazard from this appliance.
Page 7
Operation of Surface Burners Burner Baffle Operation of electric igniters should be checked after range and 1" Flame supply line connectors have been carefully checked for leaks and range has been connected to electric power. Check Surface Burners To check for proper lighting, push in and turn a surface burner knob to the LITE position.
Page 8
Model and Serial Number Location The serial plate is located under the lift=up cooktop. When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. Your serial plate also tells you the rating of the burners, the type of fuel and the pressure the range was adjusted for when it left the factory.