Table of Contents
Advertisement
C.
Level and Position Range- Level range by adjusting the
(4) leveling legs with a wrench. Note: A minimu m clearance
of 1/8" isrequired between the bottom of the range and the
leveling leg to allow room forthe bracket. Use a spirit level
to check you radjustments. Slide range back into position.
Visually check that rear leveling leg is inserted into and
fully secured by the Anti-Tip Bracket by removing lower
panel orstorage drawer. For models with a warmer drawer
or broiler compartment, grasp the top rear edge of the
range and carefully attempt to tilt it forward.
(17mm)
Range Side --_
" "
2.
Provide an adequate
gas supply.
This unit is designed to operate on 4" natural gas or 10" LP/
Propane manifold pressure. A convertible pressure regulator
is connected to the manifold and MUST be connected
in
series with the gas supply line regardless of which type of fuel
is being used.
Care must be taken during installationof range notto obstruct
the flow of combustion and ventilation air.
For proper operation, the maximum inlet pressure to the
regulator should be no more than 14 inches of water column
pressure. The inlet pressure to the regulator must be at least
1 inch greater than regulator manifold pressure. Examples: If
regulator is set for natural gas 4 inch manifold pressure, inlet
pressure must be at least 5 inches; if regulator has been
converted for LP/Propane gas 10 inch manifold pressure, inlet
pressure must be at least 11 inches.
Leak testing of the appliance shall be conducted according to
the instructions in step 4g.
The gas supply line should be 1/2" or 3/4" I.D.
120V Outlet on Rearof
Wall and Area for Thru
the Wall Connection of
PipeStub and Shut Off
Valveis ShadedArea.
Area for Thru
" " _'_1_-
Wall
the FloorConnectionof
Edge
_Pipe Stub and Shut Off Valve.
3.
Seal
the openings.
Seal any openings in the wall behind the range and in the floor
under the range after gas supply line is installed.
4.
Connect
the range
to the gas supply.
To prevent leaks, puta pipe joint sealant on all male (outside)
pipe threads.
Your regulator is in one of the two locations shown below.
Do not allow regulator to turn on pipe when
tightening fittings.
@@
@@
I:rm_A_ce_
to Regulatnn
PemoveI(IckFanel,
S_rgert_rav,_, or
wan,n_ Draw_.
Pressure
(SeeOwner's Guide
Regulator
for InStnL'_lors).
Io_Uon at
If Equippedwith
raraf
Broiler _r_v_,
Open Broiler _'_.
Pressure Regulatorlocation
4
Advertisement
Table of Contents
