Table of Contents
Advertisement
Quick Links
INSTALLATION
AND SERVICE
MUST BE PERFORMED
BY A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE.
If the information
in this manual is not followed
exactly,
a fire or explosion
may result
causing
property
damage, personal
injury or death.
FOR YOUR SAFETY:
--
Do not store or use gasoline or other flammable
vapors
and liquids in the vicinity of this or any other appliance.
--
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do nottouch
any electrical
switch; do not use any phone
in your building.
• Immediately
call your gas supplier
from a neighbor's
phone.
Follow the gas supplier's
instructions.
• If you cannot
reach
your
gas supplier,
call the fire
department.
--
Installation
and service must be performed
by a qualified
installer, service agency or the gas supplier.
• ALL RANGES
CAN TIP.
• INJURY TO
PERSONS
COULD
RESULT.
• INSTALL
ANTI-TIP
DEVICE
PACKED
WITH RANGE.
• SEE
INSTALLATION
INSTRUCTIONS.
RANGE
OVERALL
DIMENSIONS
1
46-3/4"
Maximum
445/8'
Door Open
297/8"---I_/, _"
36+1/8 '
1
Minimum to
Wall on Either
Minimum
Side of Range
|
Above 36"
2" _
_F
Height•
36"
Minimum to
1_13"4_1
_k,, Cabinets on
Maximum Depth
18
Either Side
for Cabinets
it']
__
;
of Range.
Above Range Top.
_---25"_
30" _
0" ClearanceBelowCooking Top and at Rearof Range.
Clearances
and Dimensions
1.
LocationiCheck
location where the range will be
installed. Check for proper electrical and gas supply,
and the stability of the floor.
2.
Dimensions
that are shown must be used. Given
dimensions
provide
minimum clearance.
Contact
surface must be solid and level.
Fram;ais - Pages 11-20
EspaSol - Paginas 21-30
PIN 316259300 (0401)
Important
Notes
to the Installer
1.
Read all instructions
contained
in these installation
instructions before installing range.
2.
Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important Note to the Consumer: Keep these instructions
with your owner's guide for future reference.
Advertisement
Table of Contents
Related Manuals for Frigidaire FGF312ASA
Summary of Contents for Frigidaire FGF312ASA
- Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY teach them the proper, safe use of all appliances. Never leave the oven door open when the range is unattended. INSTRUCTIONS Do not store items of interest to children in the cabinets above the range. Children could be seriously Installation of this range must conform with local codes or, in burned climbing on the range to reach items. -
Page 3: Before Starting
Locate the Bracket Using the Template - (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available). - Page 4 Level and Position Range- Level range by adjusting the (4) leveling legs with a wrench. Note: A minimu m clearance of 1/8" isrequired between the bottom of the range and the leveling leg to allow room forthe bracket. Use a spirit level to check you radjustments.
- Page 5 Gas connection for electric ignition models For an accurate pressure check have at least two (2) other top Manual Flare Flexible FlareUnion Pressure burners burning. Be sure the gas supply (inlet) pressure is at Shutoff Union Appliance Adaptor Regulator least one inch above specified range manifold pressure. The Valve Conduit gas supply pressure should never be over 14"...
- Page 6 Grounding Instructions knob to the LITE position. You will hear the igniter sparking. The power cord of this appliance is equipped with a 3-prong The surface bumershould light when gas is available to the top (grounding) plug which mates with a standard 3-prong grounding burner.
- Page 7 Operation of Oven Burners and Air adjustment The airshutter (adjustment) foreach of the four top burners is Oven Adjustments located at the open end of the venturi tube and sets on the hood of the valve. 9a. Electric Ignition Burners Operation of electric igniters should be checked after range Should the air shutter need adjusting, rotate the air shutter to and supply line connectors have been carefully checked for...
- Page 8 Standing Pilot Oven Burner To light the oven pilot, proceed as follows: Turn the oven thermostat knob to OFF. Remove oven bottom, see step 10 for instructions on removing the oven bottom. Light the oven pilot with a match. The oven pilot should burn with a stable flame after a few seconds operation and should Waist-High Burner have a small flame visible only at the opening in the top of the...
-
Page 9: Gas Conversion
PressureRegulator location 12. Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by I:rm_ Acce_ either adjusting the leveling legs or by placing shims under the Regulatm: Remove lack F_md, corners of the range as needed. - Page 10 lc. Convert the Pressure Regulator- Non-Self- Cleaning Standing Pilot Models (Shown in RaisedPosition) Remove the cap from the pressure regulator. Remove the plunger from the cap. Turn the plunger with the enlarged end down for LP/ Propane use. Turn the plungerwith the small end down for Natural gas use.