Buderus Logano GC124 II User Manual page 9

Start-up instructions
10. Light the pilot burner with a match using the
furnished match holder. Insert the lit match through
the sight glass ( Fig. 6).
11. After lighting the pilot, keep the red pilot ignition
button pressed in for an additional minute
( Fig. 7).
12. Release red pilot ignition button (
pilot ignition button should move back and the pilot
burner should remain lit. If the pilot burner shuts off,
turn the gas control knob back to "OFF", and shut off
the main gas supply. Power done the heating
system and contact your heating service contractor
or gas utility company.
RISK TO LIFE
due to poisoning by leaking gas.
If the red pilot ignition button does not pop
WARNING!
up when you release it, you must proceed
with the following steps:
When the pilot burner shuts off after re-
peated lighting attempts, you must shut
off the gas control knob to "OFF" to
avoid spillage of gas.
Shut off main gas supply.
Contact your service technician or gas
supplier immediately and have the fault
repaired.
13. Turn gas control knob (
to ON position. The gas control knob can only be set
to ON if the red pilot ignition button is out (
14. Close boiler front panel.
15. Open main gas supply.
16. Turn on electric power to heating system.
17. Set thermostat to desired room temperature.
18. If the heating system does not start operating, follow
the instructions for "switching off gas supply to
boiler" ( Chapter 3.3, page 10) and inform your
customer service technician or your gas company.
We reserve the right to make any changes due to technical modifications.
User manual Gas Boiler Logano GC124 II/SP • Issue 07/2006
Fig. 7). The red
Fig. 7) counterclockwise
Fig. 7).
Fig. 6 GC124 SP boiler
1 Sight glass
2
1
Fig. 7 GC124 SP gas valve
1 Gas control knob (shown in the "ON" position)
2 Red pilot ignition button
3
1
9