Gas Conversion - Jenn-Air JDR8880RDS1 Installation Manual

RANGE ADJUSTMENTS
Top Section - Electric Ignition
To operate, push and turn top burner knob to the LITE
position. The top burner will light. To turn OFF spark after
the top burner has ignited, turn knob to Ht setting.
NOTE: Top burners are not adjustable.
Air Shutter - Bake/Broil Burner
NOTE: If oven burner does not ignite, check oven gas
shut-off position at the regulator.
a. The approximate length of the flame of oven burner is
a 1/2 inch distinct inner blue flame, figure 7.
GAS CONVERSION
SEE INSTRUCTIONS FOR GAS CONVERSION
LOCATED ON THE BACK OF THE RANGE.
FIGURE 7
Bake/broil burner flame can be checked as follows:
1. Yellow flame on burner - open burner air shutter
to the widest opening that will not cause the flame
to lift or blow off the burner when cold. (See #2 on
figure 8). Some yellow tipping on LP is normal.
2.
Distinct blue flame but lifting - close burner air
shutter to the point where it will not cause the
flame to lift or blow off the burner when cold. (See
#2 on figure 8).
SHUTTER
FIGURE 8
-10-