Jenn-Air JDR8880RDS1 Installation Manual page 7

CONNECTING THE RANGE
FIGURE 5
4-Wire Service Cord or Conduit Installation
(Mobile Homes Or As Required By Codes)
1. The copper ground strap connected between the
neutral (middle) post of the main terminal block and the
chassis MUST be cut off as shown in figure 5. Save the
green ground screw to attach the ground from the 4
wire cord. Only a 4 wire cord or conduit should be
used.
2. If bare copper or aluminum wiring is used, attach
adapter lugs as shown in figure 5. (See Bare Wire
Connection). Torque specifications are shown below,
3, The ground wire from the service cord or conduit must
connect to the range chassis using the green ground
screw.
4. The white wire of the service cord or conduit must
connect to the neutral (middle) post of the main
terminal block. The other two wires of the service cord
connect to the red and black posts of the main terminal
block, respectively. If using bare wire, attach wire to
ACCEPTABLE - 4 WIRE
appropriate lug as shown. Torque specifications are
shown below.
5. An appropriate strain relief for service cord or conduit
MUST be attached to the conduit plate.
Conversion
From 3-Wire To 4-Wire
Service
(Free-standing Model With 3-Wire Service Cord
Attached).
Disconnect range from power. Remove the access cover
on back of range and remove the 3-wire service cord from
the main terminal block. Follow instructions as outlined in
figure 5 to connect the 4-wire service cord,
NOTE: Cord replacement - ONLY a power supply cord
rated at 240 volts minimum, 40 amperes or 50 amperes
power supply cord that is marked for use with nominal 1
3/8" (34.93 mm) diameter connection opening, with
closed loop terminals and marked for use with ranges
shall be used.
PLUG INSTALLATION
BLACK
CHASSIS
GROUND
STRAIN
RELIEF
I-I12 13,8 CM)
MINIMUM
}
Z OUTLET RECEPTACLE
MOUNTEDFLUSH
TO WALL
MIDDLE WIRE OF
/
SERVICE CORD
OR CONDUIT
ADAPTER--_"'_...._ -'"--WHITE
LUGS LOCATED _'_'
IN LITERATURE KIT _"_-'BLACN
BARE WIRE TOROg[ SPECIFICATIONS
LUG ATTACHED TOTEWWAL RLOCK - ZOJN-LO
FLOOR
_USE WITH CONDUIT,
REMOVE BRACKET, FLIP
RE-ATTACH Tire SMALL
HOLE VISIBLE,
OUTLET RECEPTACLE TO BE ROTATED
IN ACCORDANCE WITH LOCAL CODES
IO-14 ZO IN'LB
8 Z$ IN'LN
4-$ 35 IN-LB
ALTERNATIVF INSTA!IATION
RED
FIGURE 5
-7-